Hey everyone. I just installed a pair of V&H Ovals slip ons, and fuelpak. Soundsgreat compared to the stock mufflers on the 06 RKC. I felt with my hand under the where they slip over the header pipe, and I can feel equal amounts of exhaust pushing out on both sides. I imagine it is not supposed to do this. Am I missing something? Are they not tight enough? Any help would be GREAT, thanks.
OK, great, going on tomorrow. Last question, torque or just tighten them down? thanks for your help!
Use new HD clamps and torque them. I think the manual calls for 60 ft. lbs. I was suprised how hard I had to pull on a 1/2" drive torque wrench to get there. With Rush mufflers I went to 75 lbs. to get them to seal and the bolt didn't break but I'll bet it was close.