Creepshow

nice looking good ideal to

 

use your old OEM grips on your floor jack handles


i start it on with a screwdriver, then beat it on with a rubber mallet

 

FWIW, the rubber antenna's from Advance have a hard plastic base that is brittle, and they break every other month or so.

keep your receipt & package handy, and just keep swapping them out. they have like a 90 day warranty, and they always break prior...but you can't always find the receipt

 

Have you guys seen this yet for antenna on Street Glide?


Worked for me.

 

I saw that the other day and was actually thinking of doing that on the Ultra Limited..
I don't think the cable and connecter is just going to hang there..scary as hell if that gets wrap up in the wheel or belt! I guess you would just zip tie it up or better yet cable clamp it out of the way?.

 

2 Zip ties did the trick. You definitely lose some signal strength at times but I would bet its comparable to the other antenna solutions which all lose strength. For me, it was perfect. I rarely use the radio anyways, but its there if I need it and it was the cost of 2 zip ties.

 

What type of vacuum pump did you use?

 

I did a similar job. However, i ran my ant. along the left side behind the side plate and tie wrapped it along the frame. I redrilled the bracket and tapped it. you can't even see the ant with the seat off. radio actually works better...lol

 

I'm thinking the pump must be a Mity-Vac Silverline. Tho a bit harder, I drain from the bottom and use the Mity-Vac to fill from the top. Full oil change and less mess.

 

new to the forum and like your idea on the garage door opener. Aren't most of them 1.5 volts. how will applying 12v to them work????