For those of you who have the Axle Nut Torque Adapter (HD-47925), where did you get it?

Direct from Kent-Moore?
Special Order from your local dealership?
Some other place?
Did without?
Some other solution like removing the pipes?

(This tool helps youtighten the weld nut and cone nut for adjusting the secondary drive belt.)
Zanotti and the MoCo dont have them in their online databases.

Thanks,

Barton

 

big old crescent wrench 16"

 

Just buy the one from Pit Posse that usually is on ebay.

 

special order from H.D. took 4 weeks to get

 

This?

 

Yup, that be the one!

 

http://cgi.ebay.com/ebaymotors/Motor...2792QQtcZphoto

 

Barton,
Check your tool kit, I found a 36mm wrench in there. Doesn't work with a torque wrench like the one in the shop manual, though. I took the exhaust off but thinking of ordering the one you're talking about for the same reason.

 

Funny I just was looking for that today before my IDS install. I called several dealers and none had them in stock. I did it without but may order one for the future

 

Just ordered one thanks for the info, any other special tools needed to remove rear wheel/tire?