Tank emblems
#5
RE: Tank emblems
ORIGINAL: Punisher
I too am interested in the same thing. Is the emblem held on with 2 sided tape, and is the removal clean? Anyone have a picture to post?
Thanks very much
Woody
I too am interested in the same thing. Is the emblem held on with 2 sided tape, and is the removal clean? Anyone have a picture to post?
Thanks very much
Woody
[IMG]local://upfiles/18262/115BC0E660834A31B36E246EC2327A62.jpg[/IMG]
#7
RE: Tank emblems
One of the first mods I did on the bike to make it different from all the other scoots out there. Easy to remove the old emblems and then used Goo-Gone to remove the sticky residue. The hard part was getting the new emblem brackets lined up properly by myself. Had to have the wife come out and keep telling me how it looked. Once I got them set I had to bend them to match the contour of the tank and then I was good to go.
I am actually thinking about changing mine again already to something else.
I am actually thinking about changing mine again already to something else.
Trending Topics
#8
RE: Tank emblems
takes a lot of care getting emblems to look right and symetric from one side to the other. note that no many H-D emblems are parallel to the ground, most tilt to the rear slightly. it took me a long time to measure from several points to get mine to line up where they looked good. i see some that are "just stuck on" and look odd. enjoy!!
#9
#10
RE: Tank emblems
ORIGINAL: ianchris1
Was it a pretty clean install? Can you see anything left over from the original?
Was it a pretty clean install? Can you see anything left over from the original?