Kuryakyn adjustable passenger pegs
#1
Kuryakyn adjustable passenger pegs
Purchased and installed a set of Kuryakyn adjustable passenger pegs - wife likes them. After a 160 mile ride today I noticed that the left side peg was coming loose. The 7/16" bolt on the inside had come loose. I took both of them off and used some locktite blue to keep it slug. If the bolt is too tight the pegs are hard to adjust. Anyone else have a similar problem?
#2
The following users liked this post:
mitch69691234 (05-07-2022)
#3
#6
#7
Trending Topics
#8
RE: Kuryakyn adjustable passenger pegs
Make sure that when you installed them that the plastic busing is properly mated to adjustable peg bracket. I just did a service on my Dad's EGC and he has these. When I tried to reinstall them, I didn't notice the little busing had dropped off. It made them feel like they weren't tight enough on the bike. When I found and replaced the bushing, they snugged up much better, although I did hear some stress from the metal as I tightened them down good. I made sure not to overtighten them when I could hear the metal stressing.
Drel
Drel
#9
RE: Kuryakyn adjustable passenger pegs
I had the same problem when I first installed mine, if you remove the boltthe chrome plate under it should have two tangs on it to keep it from rotating when you adjust the pegs, if they are broke off the bolt will turn and every time you adjust the position the bolt will come loose, mine did this and I called kuryakyn and they shipped me a repair kit and it fixed the problem.
The following users liked this post:
mitch69691234 (05-07-2022)
#10
RE: Kuryakyn adjustable passenger pegs
ORIGINAL: philb252
Does anybody have these pegs with Rinehart TD's? I was told there is a fit problemon one side with Rineharts....
Does anybody have these pegs with Rinehart TD's? I was told there is a fit problemon one side with Rineharts....