Help with gasket placement 07 road king
#27
05-29-2018 | 05:30 AM
The tool that fits in the center of the bolt and the tool that helps remove and install the bolts inside the rocker cover are not for torquing or breaking things loose. Those two tools just make it nicer to remove and install. You don't need any special tools except proper size torque wrenches and dogbone torque adapters through all of this. You do not have to remove any motor mounts. The rear lower rocker box goes in with the rockers bolts and breathers in - you just lift the bolts over the head and under the frame.
#28
05-29-2018 | 07:09 AM
Thread Starter
|
Cruiser
Joined: Apr 2018
Posts: 123
Likes: 8
From: Ohio
Breather
Yep I’m good on that ed. I’m just trying to figure out how that breather goes together it was in separate pieces. The picture that DAWG sent doesn’t look right if you put it together that way. I put it together kind of in the same orientation has the stock one I posted a picture can one of you guys tell me how it actually goes together?
#30
05-29-2018 | 01:50 PM
Road Master
Joined: Apr 2011
Posts: 899
Likes: 88
From: Red Deer, AB
When I changed my cams I also put in the updated breather filters. I also reamed the drain hole to allow better draining of oil from the top end as was recommended. I think it was a .125" bit. If you search you will find it on here. Apparently it reduces misting into the air filter. Seemed to work on mine but I don't know if that is because of the new breather filters, the drain hole modification or a combination of the 2.
Last edited by RevBlk; 05-29-2018 at 01:58 PM.