Properly bleeding ABS brakes... what's the cheat?
#1
The following users liked this post:
Aviator5456 (06-09-2019)
#2
Well, the cheat as you call it is to not let the brake fluid reservoir go empty as you are bleeding the lines. I have used a Mity Vacuum pump to do my ABS brakes 4 times over the years and I never let the reservoir run empty when adding fluid. If you do let it run empty you will likely let air into the lines and you will end up at the dealers with a bill for a session on their Digital Technician to reset everything. I put the brake fluid into a plastic ketchup squirt bottle to keep adding fluid. Cover up your gas tank with a piece of plastic because no matter how careful you think you are going to be, you will probably spill some. Oh ya, the cap on the reservoir will tell you what kind of fluid to use. Good luck.
#3
The following 2 users liked this post by lp:
Rusty Dailey (04-04-2023),
slippin_jimmy (08-16-2023)
#6
I've bled ABS brakes a few times when installing longer brake lines. All seem to go well and no ABS light staying on, but you know what, I still took it to the dealer for 1/2 hour labor cost and had them run it on the digital tech. IMHO brakes are nothing to be fooled with and you don't want to find out you should have done that while in the middle of an emergency stop and TBone, and find out the ABS failed. I figured the insurance of $40 was well worth it.
#7
Trending Topics
#9
#10
I bleed the brakes normally with a clear tube and a wrench, adding fluid as needed (after soaking out the old fluid in the master cylinder with a clean rag).
Then I go ride the bike and cycle the ABS and flush the lines again. I do this once a year in my ABS bike.
As mentioned, do not turn on the ignition during the process.
Then I go ride the bike and cycle the ABS and flush the lines again. I do this once a year in my ABS bike.
As mentioned, do not turn on the ignition during the process.
The following users liked this post:
2011FBL (06-20-2021)