Welding Y pipe
#22
#24
Progjet complete. I cut the pipe still on the bike . Sawsall no problem. After I got the 3" piece out I noticed the pipe is not round there,there is an indent on the back side of pipe, so the freeze plug would'nt fit. I took the pipe off and took both pieces to the local muffler shop where they heated it up on a mandrel to round it out so the plugs then fit. He welded it in. $20 to him for lunch. Then a trip to dealer for new flange clip,gasket and nuts for studs. $10 to them. Got home put back together and went for 40 mile ride let it cool down then checked all fasteners for snug. The summary is I love the sound now -- big difference no excess heat on right thigh no codes. Reset FUELPAC for duel exhaust before the ride. So for approx. $35 I got the results I was hoping for. This mod might not be for everyone, but why spend $400? When you get same results for $35.
I have done the same to my 2014 street glide with Vance and Hines pipes and air cleaner except I haven’t been to a welder yet. Just using a temp plug. Now when I first cranked it loped and sounded funny so I turned it off. Tried to crAnk again and it wouldn’t start. Sounded/smelled like it was flooded. I took the plug out of the crossover and it fired right up. I believe I have the FUELPAK as well but I’m not sure how to reset it to accommodate this mod which I believe could be the problem. I want it to run properly with a temp lug before I get to welding on my pipe. Please let me know what I can do. Thanks
#25
First, digging up a 4 year old thread isn't going to get you a good response, but second...open/start your own thread probably will.
I see it's your first post and you're a new member.
Welcome to the forum, lots of good info here.
It's kinda an unsaid taboo to dig up old threads, just FYI.
I see it's your first post and you're a new member.
Welcome to the forum, lots of good info here.
It's kinda an unsaid taboo to dig up old threads, just FYI.
Thread
Thread Starter
Forum
Replies
Last Post
mjlevi
2014-2023 Touring Models
6
06-29-2015 06:11 PM