Can I get you guys to post pictures of your ultras with the tour pak off. Preferably from the rear end. want to get some more ideas of how to mount my license plate now that the tour pack is off. Thanks.

 

I have a Badlander enroute to give it a more low profile look. Will most likely take the sissy bar off too.

 

Softbrake makes a mount that drops the plate below the standard light bar.

 

I cut and drilled a piece of stainless and mounted it with the turn signal bar.

 

2010 roadking signal bar and plate mount on my 09, uses same holes- 2 bolts:



the signal bar is a little narrower, the plate light led wires are married into the fender tip light.

get the solidtop lens...I use a BAL and now have red lenses on the signals- the run., stop, turn module


find a RK guy who is adding a custom or FLHX set-up.

i paid about $65 for this from another rider.

mike

 

Interested in this as well. Good looking bikes in this thread

 

https://www.hdforums.com/forum/new-r...00872-a-2.html

post #11.

This is the license plate bracket which comes with the quick release kit. I have been looking for options but as of now, I bent it forward and it does not look bad under the quick release Air Wing luggage rack (not pictured).

 

Mines no Ultra, but had the same set up. I switched out my entire rear light set up. R/B/T all from a 2009 SG.

 

Just found a couple pictures:

 

That's a good idea, I don't want to drill my fender.I wonder if there is away to put a slight curve in the plate holder