Doing a 3.37 primary gearing setup, DO NOT hesitate! Do it!
#91
09-04-2008, 08:19 AM
I hate forums sometimes. I worked hard to engineer and sometimes buy the impossible to find parts to make my ride better, faster, etc. Then some poster comes along to sound cool and gives all the secrets away. Maybe you all want to have your kids wear the same uniform to school, or standardized healthcare. I dont discriminate I hate everyone equally. For the record I wont give out info on where to find what parts but gearing always prevails!
#92
09-05-2008, 01:45 AM
Former Sponsor
#93
09-05-2008, 02:16 AM
I hate forums sometimes. I worked hard to engineer and sometimes buy the impossible to find parts to make my ride better, faster, etc. Then some poster comes along to sound cool and gives all the secrets away. Maybe you all want to have your kids wear the same uniform to school, or standardized healthcare. I dont discriminate I hate everyone equally. For the record I wont give out info on where to find what parts but gearing always prevails!
#94
09-05-2008, 03:26 PM
This is interesting stuff. I was talking to my mech last night about this and he was telling me to just change the rear sprocket on the wheel, 66 teeth on the 07's-up to 70 teeth that came on the earlier models. He said the only concern was belt stretch but at over 16k on it, that shouldn't be a problem. We are going to give it a try.
Thread
Thread Starter
Forum
Replies
Last Post
dlrshort
Primary/Transmission/Driveline/Clutch
3
05-23-2009 08:58 PM
