A word about installing ROCKOUT rocker shaft inserts...
#32
There are no issues with the pushrods. Just make sure the ends are seated in the pockets in the rockers & you're good to go.
One caution... should you remove the pushrods for any reason, don't mix them.... they're not the same length.
Thanks for your order
One caution... should you remove the pushrods for any reason, don't mix them.... they're not the same length.
Thanks for your order
Its almost worth it to add adjustable Push rods when doing this mod
makes a future CAM change easier
#34
Personally, I would hold off on the adjustable push rods until you need them. I've never installed them with the exhaust on the bike but I've readjusted them that way. PITA!! Also, you're introducing another adjustment and another possible source of valve train noise. If you install a cam in the future, you can cut the standard push rods a lot quicker than you can break down the adjustables. Just my $0.02
#35
Personally, I would hold off on the adjustable push rods until you need them. I've never installed them with the exhaust on the bike but I've readjusted them that way. PITA!! Also, you're introducing another adjustment and another possible source of valve train noise. If you install a cam in the future, you can cut the standard push rods a lot quicker than you can break down the adjustables. Just my $0.02
2010 Limited with some stuff
#36
For me, the header pipes were in the way, big time, leaving you with hardly any wrench stroke. It gets a bit worse when you're doing the second rod on each side when you have another pushrod tube to work around as well. Not impossible but "a bit fiddly".
#37
#38
Bleed down time is the time from when you tighten the rocker support bolts down to the time you can rotate the engine again.
__________________
NO, they DON'T all do that!
ROCKOUT rocker shaft inserts... make the tapping STOP! From the guy that FOUND and CURED the problem NO ONE ELSE COULD, thank you for your support!
Ordering & info http://www.rockout.biz On ebay! ... CLICK HERE
Also on amazon.com...
Imitated, never equaled... ROCKOUTS!
Ordering & info http://www.rockout.biz On ebay! ... CLICK HERE
Also on amazon.com...
Imitated, never equaled... ROCKOUTS!
#39
#40
Over simplification to be sure but that's the gist of it.