My MOPAR sublime green and matte black paint project has started
#52
It's really looking good, and I am envious of your skills!
The end of the wide stripes, to my eye, looks unfinished. Did you consider either continuing the stripes through the bezel and bottom for the front fairing, or just doing the whole bezel black? I think the second would have really finished it off...
Not criticizing, just offering a different POV.
The end of the wide stripes, to my eye, looks unfinished. Did you consider either continuing the stripes through the bezel and bottom for the front fairing, or just doing the whole bezel black? I think the second would have really finished it off...
Not criticizing, just offering a different POV.
I toiled over all the things you mentioned, I even masked it off down the front of the fairing, but I wasn't sure it look good, especially with all the curves in the bezel, it was really hard to keep the lines straight. They looked straight to me, but it's so hard to tell until it's painted and un masked. So I ended up just doing the top.
I was thinking about doing the inside of the bezel black but was afraid that my masking lines would be wavy.
#53
#55
Tank , rear fender and fascia sprayed green yesterday, and sprayed the stripes today.
The rear fender has been fighting the whole way, first iwth pulling it off, having to fill the holes from the fender to light, and today, the masking would not stick. Finally got it sprayed, and I had some issues with the paint sticking an the very bottom of the fascia, some of it peeled up when I removed the masking.
Going to have to sand and re finish the bottom rung.
Later on I will get the tank and dash together, and will get the fender on without the fascia. And get the wheel back on.
The rear fender has been fighting the whole way, first iwth pulling it off, having to fill the holes from the fender to light, and today, the masking would not stick. Finally got it sprayed, and I had some issues with the paint sticking an the very bottom of the fascia, some of it peeled up when I removed the masking.
Going to have to sand and re finish the bottom rung.
Later on I will get the tank and dash together, and will get the fender on without the fascia. And get the wheel back on.
Last edited by steelerdude1; 05-10-2015 at 03:34 PM.
#57
#59