Ready to burn it to he ground.
#11
Is the check engine light on? Codes? No throttle is usually caused by the TGS wiring not being hooked up correctly. The other possibility is the TPS on the FI throttle body - that connector/wiring can cause the same problem. The codes will tell you which.
Are you using the SE TGS? Did you put the pins in the right holes in the connector? Are they seated correctly? Just going thru this step by step - it's frustrating but not many causes. Joe
edit - I see you have a 2014, CAN BUSS troubleshooting will be different than the older TBW bikes...
Are you using the SE TGS? Did you put the pins in the right holes in the connector? Are they seated correctly? Just going thru this step by step - it's frustrating but not many causes. Joe
edit - I see you have a 2014, CAN BUSS troubleshooting will be different than the older TBW bikes...
#12
#13
#14
#16
2010 Limited with some stuff!!
#18
2010 Limited with some stuff!!
#19
Definitely at the minimum tape it up, did my buddies Road Glide this time last year. He bought pre wired bars from Avalanche Harley in Denver. Installed the bars and no throttle. Green connector had come apart when they fished the wires through. I ended up cutting and soldering/ heat shrinking and cussing for several hours rewiring the bars. Ended up putting his black controls on and removing the chrome ones it came with anyways so he wasted his money and my time buying prewired bars in my opinion anyways.
#20
Definitely at the minimum tape it up, did my buddies Road Glide this time last year. He bought pre wired bars from Avalanche Harley in Denver. Installed the bars and no throttle. Green connector had come apart when they fished the wires through. I ended up cutting and soldering/ heat shrinking and cussing for several hours rewiring the bars. Ended up putting his black controls on and removing the chrome ones it came with anyways so he wasted his money and my time buying prewired bars in my opinion anyways.
2010 Limited with some stuff!!