I have the mono tubes in my '12 Ultra. Second best improvement I made next to upgrading the rear suspension as well. Handles much better and no more front brake dive.

 

I just put a set of standard height in my 2011 Electra Glide. I ride 2 up a lot, so I installed both clips. I already installed the 944's out back. Only a couple months before I can actually test ride it. Stupid Ohio winter!

 

One clip here. 5-10 175, happy as a clam.

 

Nope, the clips are for preload. For -1" it's a different kit.

 

Yes I put both clips in. Not that the ride is horrible, but I think it would improve by removing 1 clip. I to have read about people being happy with just the 1 clip AFTER I installed them

 

Been there done that.

It depends on the riders weight.

Riding 2up doesn't effect the front suspension.

Those are my numbers too and two clips was much too harsh of a ride.

I was in the same boat and ended up tearing them down to go with one clip.

 

Mine were defective with a few thousand miles, went to Ohlins and very happy I did.

 

Ohlins for the front suspension? Can you tell me where I can find them.

 

Is it a PIA to install and or remove clips

 

It's just a time consuming job. Removing or adding a clip requires a complete tear down. Including removing the 6mm screw and the fork seals as well.

I had extra fun since I have a hidden axle.