Posers' Coffee House, All Bullshit Accepted, Part VI
#1221
Join Date: Jul 2008
Location: On a hill among the hills, PA
Posts: 112,202
Received 1,313 Likes
on
1,028 Posts
Dunno why... but the axle was long... could put pressure on the swing arm by shimming spacers out but rather start at zero myself....
#1222
Join Date: Jul 2008
Location: On a hill among the hills, PA
Posts: 112,202
Received 1,313 Likes
on
1,028 Posts
Made a 5/8" thick spacer for the rotor side to the hub... needed the rotor closer to the swing arm to make my bracket werk......
#1223
Join Date: Jul 2008
Location: On a hill among the hills, PA
Posts: 112,202
Received 1,313 Likes
on
1,028 Posts
This 1" axle is some hard azzz steel.... reminds me of gun barrel steel 4160 or sumpin like dat!
#1224
Join Date: Jul 2008
Location: On a hill among the hills, PA
Posts: 112,202
Received 1,313 Likes
on
1,028 Posts
Whats matter with yer axle????
#1225
You guys are right tho & thanks for the input. I gotta discretely mention it to her. Be a few days before I get back over there. (She's not fat)
#1226
#1227
It was stuck in the spacer. Punched it out too hard. It split down the center about 1 1/2". Had to order a new one. Effin $78.
#1228
In Softees defense he's a busy boy & not rich like some people. Get his head all wrapped up in fixin the motor then it's like fukin tires are goin bald. ***! It's always somethin...
#1229
Join Date: Jul 2008
Location: On a hill among the hills, PA
Posts: 112,202
Received 1,313 Likes
on
1,028 Posts
That sucks.... 1" axles are hunnert bucks... I gottem to throw it in with the frame...
#1230
Yup.Bout sums it up. No worries.