TOAK, The Thread of All Knowledge Part XIII
11-12-2019, 09:12 AM
Join Date: Jan 2011
Location: Southeast Michigan 15 Minutes East Of Hell
Posts: 149,135
Received 49,835 Likes
on
19,328 Posts
She was / is one crazy Bit¢h !!
11-12-2019, 09:14 AM
Big Kahuna HDF Member
Yep, don't need that many but I'm guessing that 25% will be bad. need any?
11-12-2019, 09:16 AM
Join Date: Jan 2011
Location: Southeast Michigan 15 Minutes East Of Hell
Posts: 149,135
Received 49,835 Likes
on
19,328 Posts
No thanks .. I got plenty of Duct tape :>)
11-12-2019, 09:18 AM
Ultimate HDF Member
Morning Bob, Chris and Larry. Still looking like I will be outta here work wise around the end of March, not wanting to extend that any further than I have to, but it may come to that.
11-12-2019, 09:20 AM
Big Kahuna HDF Member
Haha...
Found something harder to weld than 20 ga. sheetmetal. Expanded wire mesh to 3/16" steel. I measured it and it's so thin it doesn't show up on a gauge chart 
Found something harder to weld than 20 ga. sheetmetal. Expanded wire mesh to 3/16" steel. I measured it and it's so thin it doesn't show up on a gauge chart
11-12-2019, 09:25 AM
Join Date: Jan 2011
Location: Southeast Michigan 15 Minutes East Of Hell
Posts: 149,135
Received 49,835 Likes
on
19,328 Posts
An old timer who used to come in the shop talked about "welding" the tin foil that chewing gum was wrapped in
11-12-2019, 09:25 AM
Join Date: Jan 2011
Location: Southeast Michigan 15 Minutes East Of Hell
Posts: 149,135
Received 49,835 Likes
on
19,328 Posts
So that's a good thing, right?
11-12-2019, 09:37 AM
Ultimate HDF Member
Oh yea! I would not be unhappy if they said go now!
The following users liked this post:
Uncle Larry (11-12-2019)
11-12-2019, 09:47 AM
Big Kahuna HDF Member
Did he ever show you?....didn't think so.
The following users liked this post:
Imold (11-12-2019)
11-12-2019, 09:48 AM
Big Kahuna HDF Member
Terry, plan on doing anything else?