Nice floor!

 

Greg, worth the visit?

 

David says the floors need work.

 

Oh, yeah. This will be worth the jet lag. The exchange rate is very favorable.

 

Good enough for me.

 

Cool! What's the exchange?

 

Very "Uptown" !

 

Sometimes what should be a simple job causes me the worst time. I’m wanting to mount some LED taillights on the RV. Because it’s a toy hauler the only brake lights are in the bumper (down low) , as most of the rear is the ramp door. To either side of the ramp is a square tube steel frame. I figured I could drill a hole from underneath and fish the wires through this frame. I have very limited access to where I have to drill and the steel is about 3/16” thick. I tried using a 1/2” hole saw bit (the kind used for making holes in sheet metal) for rust proofing. Well , it was like cutting down a tree with a nail file. I’m going to have to devise a plan B.

 

1USD to 1 1/2 AUD.

 

Chuck, think step bits.

https://www.homedepot.com/b/Tools-Po...s/N-5yc1vZc90q