TOAK, The Thread of All Knowledge Part XIII
Join Date: Jan 2011
Location: Southeast Michigan 15 Minutes East Of Hell
Posts: 149,145
Received 49,840 Likes
on
19,329 Posts
Okay fellas, so stop me before I do something crazy!
I'm thinking I should drill and tap the top clamp to keep my bars from slipping again. I have a tap set that includes a 1/4x-20 bit and I can readily get 1/4x20 set screws. I'm thinking two of those would be enough to keep the bars from slipping again. It would be a cheap and hopefully effective solution.
I'm thinking I should drill and tap the top clamp to keep my bars from slipping again. I have a tap set that includes a 1/4x-20 bit and I can readily get 1/4x20 set screws. I'm thinking two of those would be enough to keep the bars from slipping again. It would be a cheap and hopefully effective solution.
Join Date: Mar 2014
Location: TOAK Northern Branch
Posts: 34,574
Received 2,087 Likes
on
1,601 Posts
Big set screws.
Once you get your hole drilled in the clamp, make sure you give the bars a small dimple for the set screw to go into with the drill bit. Don’t drill into the bars, just a little dimple. It will make it more effective.
Once you get your hole drilled in the clamp, make sure you give the bars a small dimple for the set screw to go into with the drill bit. Don’t drill into the bars, just a little dimple. It will make it more effective.
The following users liked this post:
Imold (04-14-2021)
I have, but they still slipped. The clamp is as tight as it can go. There's just too much leverage on the bars and I don't pull on them, but when I hit a bump they slipped. I like where they are now, and they don't hit the tank, but it's so close that if they slip again, it's a nasty roadside repair I don't want to do hundreds of miles out.
Thanks Russ!
Searching around, Hill Country Custom Cycles has a clamp that does just this with 3 set screws for $60. I'm driving right by there tomorrow. It's worth looking at.
Thanks Russ!
Searching around, Hill Country Custom Cycles has a clamp that does just this with 3 set screws for $60. I'm driving right by there tomorrow. It's worth looking at.
Nice job on those pavers Jeff! Morning Mick, Larry, Greg, Markcus, Chris, Tim, Doc, Lou Al, and John.
Join Date: Jan 2011
Location: Southeast Michigan 15 Minutes East Of Hell
Posts: 149,145
Received 49,840 Likes
on
19,329 Posts