TOAK, The Thread of All Knowledge Part XIII
Re-Morning, Woods....just finished trying out my new Belgian waffle maker...works great!
Bob, I used Krusteaz with their recipe for waffles. They were very good.
Bob, I used Krusteaz with their recipe for waffles. They were very good.
The following users liked this post:
nevada72 (03-10-2021)
Quick check in. I didn't ride the FLSTSB or the FLHX in today. Too wet and windy, but otherwise nice temps, in the lower 60s. Shuffle is kicking off again hard this week, hit the ground running and haven't stopped. But one more in jail and tracking a second. Later.
Al, quick side note. I have the Kodiak on request and Tanya will get me some, unless you think the Krusteaz is better and I'll try that instead.
Chuck ride safe today.
Al, quick side note. I have the Kodiak on request and Tanya will get me some, unless you think the Krusteaz is better and I'll try that instead.
Chuck ride safe today.
Chris, honestly they all taste the same to me. I think my taste buds are screwed up from the meds. Either one is fine,. I've been making them with milk instead of water and adding an egg.
I will definitely try the milk and egg approach too then. I'll report back when this task is completed. Likely this weekend when I make breakfast for everyone. Again, still practicing so I'll use my family as my guinea pigs, I like you guys too much haha.
I did, cops were everywhere....I did the speed limit....screw it I still got paid
Morning all, I had my bike inspected last night before letting the end of the month sneak up on me and the inspector mentioned that my rear rotor was too shiny, like chrome and didn't have any grooves in it. He asked if I had any trouble braking thinking this indicated some sort of warpage, or other problem. I told him I had no issues and was glad the rotor was not scored. I checked the pads and rotor about a month ago when I changed the oil and he agreed that the pads looked fine. Passed inspection anyway but I thought it was a little odd that he thought my rotor was to shiny and smooth. Maybe I'll let the pads go awhile until they are metal to metal and get me some grooves.