Greg, I saw that your neck bearing change was not an enjoyable experience.
It wasn't terrible, but don't wanna do it again.
Originally Posted by Uncle Larry
So what did your neck bearings look like once removed? Hammered races? Pitted rollers?
Originally Posted by rwhisen
Hammered races, yes, pitted rollers, no.
I ended up using a Dremel to cut the races out and off of where they were. Time consuming trying to be careful in a confined area. This after trying to use the service manual's suggestion of heating the race on the stem til it falls off. Wasted 1/2 an hour with that. I will probably have to make an adjustment to the fall-away after I get a ride in.