TOAK the Thread Of All Knowledge IX
07-24-2017, 03:52 PM
Seasoned HDF Member
Afternoon Woods and Woodette!
Mick, got your package in the mail today. Will let the kids open it when they get back from swimming at a frinds house. Thanks to you, Russ, Greg and all the other Woods for sending them chips.
Mick, got your package in the mail today. Will let the kids open it when they get back from swimming at a frinds house. Thanks to you, Russ, Greg and all the other Woods for sending them chips.
07-24-2017, 03:52 PM
Moderator
Believe me, sometimes those marks are hard to see but Izzo can spot them in a second!
07-24-2017, 03:53 PM
Big Kahuna HDF Member
Follow up to shake, rattle and roll Ultra....I was over at shop, we opened it all up and every stupid part in there looked perfect, tensioner was fine,chain had 5/8" slack, no wear on anything. Pulled the clutch assembly off and could see the end of trans shaft looked like it had been heat treated. Bearing had heated up so much it melted and deformed the plastic and could actually see the ball bearings inside! Verified it with Mark and he said : That'll do it, but funny that it would go so soon"...Made in Japan bearing...new one should be ordered.
07-24-2017, 03:53 PM
Join Date: Jul 2008
Location: On a hill among the hills, PA
Posts: 112,202
Received 1,313 Likes
on
1,028 Posts
I have a few to send, when I get roundtuit!
07-24-2017, 03:54 PM
Moderator
Good news!
07-24-2017, 03:54 PM
Join Date: Jul 2008
Location: On a hill among the hills, PA
Posts: 112,202
Received 1,313 Likes
on
1,028 Posts
Follow up to shake, rattle and roll Ultra....I was over at shop, we opened it all up and every stupid part in there looked perfect, tensioner was fine,chain had 5/8" slack, no wear on anything. Pulled the clutch assembly off and could see the end of trans shaft looked like it had been heat treated. Bearing had heated up so much it melted and deformed the plastic and could actually see the ball bearings inside! Verified it with Mark and he said : That'll do it, but funny that it would go so soon"...Made in Japan bearing...new one should be ordered.
07-24-2017, 03:55 PM
Join Date: Jul 2008
Location: On a hill among the hills, PA
Posts: 112,202
Received 1,313 Likes
on
1,028 Posts
07-24-2017, 03:58 PM
Big Kahuna HDF Member
Buahahahha.....yep....maybe I should sell the Ultra and keep the URAL..
07-24-2017, 03:58 PM
Join Date: Jul 2008
Location: On a hill among the hills, PA
Posts: 112,202
Received 1,313 Likes
on
1,028 Posts
07-24-2017, 03:58 PM
Join Date: Jul 2008
Location: On a hill among the hills, PA
Posts: 112,202
Received 1,313 Likes
on
1,028 Posts
Get a GW.. you will be good to go!! Just don't buy a yeller one!!!