TOAK the Thread Of All Knowledge IX
I think one is thicker to allow for sensor....I think! I might have my old ones around....lemme check
Last edited by BARACU; 07-04-2017 at 02:07 PM.
Doc, have 4 old bearings Two thick and two thinner ones...not sure what goes where . Thick is .7085"....thin is ".5895"
Thicker one has endcoder in it.
Thicker one has endcoder in it.
Last edited by BARACU; 07-04-2017 at 02:08 PM.
OK, thanks. That answers my question. I knew the TOAK would have the answer.
Shows it here for my Ultra...don't know if Fugly is different.
http://partsfinder.onlinemicrofiche....A%20CLASSIC%20[KS]%20WHEEL%20-%20FRONT
http://partsfinder.onlinemicrofiche....A%20CLASSIC%20[KS]%20WHEEL%20-%20FRONT
Join Date: Mar 2014
Location: TOAK Northern Branch
Posts: 34,574
Received 2,087 Likes
on
1,601 Posts
Yes, there is a width difference I do believe. The one bearing has a different color shield. Also maters on what side the bearing goes on. This is on 2014-up
Good job Al....Not for me, Someone ask me the question if they were the same. I did not have the answer.
I knew the difference was the encoder but did not know if there was a dimensional difference.
I knew the difference was the encoder but did not know if there was a dimensional difference.
I reckon that'll work too!