Maybe 3 hours if you're really taking your time. Getting the tank, set etc. off/on is most of the time. Once the supports are on the bench it's a 15 minute job.

 

Installation instructions are here...http://www.rockout.biz/installation-instructions

 

Replacing the original 88 jugs with 95s, 10.5 pistons, 509 cams, new lifters, and a dyno tune. If I could have afforded a new Delphi injection system, I would have done a lot more.

 

Sounds great!

Mine is also down... heads off to WFOLarry for work, as well as jugs opened up to 107.

Already have 57h cams but after 2 years I needed a little "boost" to keep me away from the M8 section at the dealer lol.

 

Cool! My lower is an Anderson.

 

I had an awesome set of Dave Mackie heads, but just couldn't use them without spending a few thousand more


No danger of me getting a Knot Head. I like my old girl (2000 FLHTCUI) just fine and she has taken me a lot of miles with no issues. Just figgered that with the miles starting to add up it was a good time to do a little work on her.

 

I figured it's a good time to do mine.... daytime temps have dipped down into the 50s here lately.

 

 

I hear something stirring upstairs (wife works nite shift).... better go look productive.

Have a great day everyone.

 

Afternoon, Woods! Takin the princess to pre-school then heading to see my buddy at his body shop. Will check in later