TOAK- Thread Of All Knowledge- Part VI
I see a whole bunch of USC fans on the plane headed to Jerry World to do battle with Alabama. Tough way to start a season of college football. Wonder who is who's cupcake?
Lunch time scoot by.
It was gonna have to come off the rim anyway for the new tube Lou. He was just tryin' to help
If you will post a pic of the wiring underneath the access plate on the motor of your lathe I might be able to tell you how it's set up.
What do you guys use to fill the tubes? Used to be a chloride solution here but now they have gone to a glycol.
It was gonna have to come off the rim anyway for the new tube Lou. He was just tryin' to help
If you will post a pic of the wiring underneath the access plate on the motor of your lathe I might be able to tell you how it's set up.
What do you guys use to fill the tubes? Used to be a chloride solution here but now they have gone to a glycol.
Whats throwing me off is the motor is numbered different than the diagram.
Not the original motor.
L1 - hot
L2 - hot
L3 - hot
If it goes flat, just run it on the rim until you get back. Screw that walking stuff!
And with 208 I need to figure out where to put the week leg.
That didn't change. Our new bearing for the Grudge Box is holding up and it's getting the living **** kicked out of it. I think it works.