Idiot move of the day
#1
Idiot move of the day
So I switched my plug wires out for the fat SE wires. Long story short the rear plug was a PIA to get on the coil with my fat fingers. Used a set of needle nose pliers and finally got it in. In the process I cut a slit in the rubber housing.
Would this cause any future problems? Bike fired right up, my main concern would be water.
See photo:
Would this cause any future problems? Bike fired right up, my main concern would be water.
See photo:
#2
I'm not really sure what that picture is supposed to be of, but did you cut the wire insulation or the boot? I doubt either would be a problem. You can always put a dab of liquid electrical tape on the cut.
Be careful, I'm sure those big wires cost money. Not that they do anything, of course.
John
Be careful, I'm sure those big wires cost money. Not that they do anything, of course.
John
#6
#7
Trending Topics
#8
#9
#10
I have my 23 year old orange (only color back then) super duper nuclear jet powered SE wires on my bike. Makes it look at least 10mph faster for sure.
John