Quick question: bar ends, etc...
#1
#2
#3
Think a 7/8" rubber expander would fit snug enough?
I was thinking of getting a pair of the below bar ends (BMX) next paycheck... 10 bucks, a little added shiny, and it says "STOLEN" on it! What's not to love!?
They're 7/8" dia. If I recall, usually Harley bars are 1" dia... I don't think the 1/8" difference is gonna be enough to cause them to fall out on the highway, if I tighten them down enough....
- CK
P.s. Here is the link, in case anyone feels like trying it themselves... Also available in black, blue, red, green, orange, white, yellow.
I was thinking of getting a pair of the below bar ends (BMX) next paycheck... 10 bucks, a little added shiny, and it says "STOLEN" on it! What's not to love!?
They're 7/8" dia. If I recall, usually Harley bars are 1" dia... I don't think the 1/8" difference is gonna be enough to cause them to fall out on the highway, if I tighten them down enough....
- CK
P.s. Here is the link, in case anyone feels like trying it themselves... Also available in black, blue, red, green, orange, white, yellow.
Thread
Thread Starter
Forum
Replies
Last Post