Pullback install. Need some advice
#1
Pullback install. Need some advice
Hey all,
So, I decided to install 3.5" pullbacks from J&P (http://www.jpcycles.com/product/214-226) with 1" pullback.
Installed the risers today and they hit the tank... I can barley turn the bars.
Has anyone run into this issue? It's really irritating, 'cause they bring the bars almost exactly where I want them.
I figure my two options are:
A) Buy 4.5" risers
or
B) Buy DK's 1" riser extensions
Also, what are my options for relocating the speedo to the headlight brow?
thanks in advance!
So, I decided to install 3.5" pullbacks from J&P (http://www.jpcycles.com/product/214-226) with 1" pullback.
Installed the risers today and they hit the tank... I can barley turn the bars.
Has anyone run into this issue? It's really irritating, 'cause they bring the bars almost exactly where I want them.
I figure my two options are:
A) Buy 4.5" risers
or
B) Buy DK's 1" riser extensions
Also, what are my options for relocating the speedo to the headlight brow?
thanks in advance!
#4
#5
#6
What size tank do you have? I installed the 3.5" pullbacks and don't have any problem (3.3 gal peanut tank). The speedometer relocation is really easy. You just get a longer set of bolts and some sort of spacer tube then bolt it onto the eyebrow. I used a couple of long sockets for my spacers because I wanted to go with something chromed. Got a couple of Kobalt brand 13 mm long sockets for about $4 each at Lowe's and used them. I painted the top of the new bolts and washers with black krinkle paint so that they would match my speedo, and it was ready to go. There's a good thread about doing the relocation over on XLforum.
#7
Trending Topics
#9
#10