he has both options I chose the rise option.. here is a good mounted pic on someone elses ride


http://www.chopcult.com/forum/showpo...7&postcount=33

 

Yikes, those holes are pretty damned ugly, and not centered? Doesn't look near 1/4" either. That IS the best looking mount I've seen though that uses the visor mounts.

 

****, what holes does it use if not the visor mount holes?

 

it uses the handlebar riser holes/bolts

 

i like it....might have to take that off your hands.

 

Well I ordered a part I probably didn't need so once I can get on the garage I'll see what I can do.

 

powedercoat rules. still can't get the brake lever to make full contact with the brake switch though. not sure what i'm gonna do but i'll figure it out.

 

Let's get a side shot!

 

much better.. bike looks quite nice as always sir

 

was hoping to get home today from the poconos and ride it but the battery's dead. all the toolin around i did on friday before i left must have seriously drained it, it's the orig. one too so gonna need a new one soon. on the tender as we speak.

here's the best side shot i can get. v&h exhaust actually don't look that bad and i noticed something with the switch, when i tighten the torx bolt all the way on top of the control pod it screws the switch up, if i don't tighten it all the way, fvckers fine.

i'm almost there, come a long way since before i started. just gotta get some kinks worked out, get the exhaust done and then relocating all the controls and eliminating what i don't need later. CRAZYORANGE!