Last edit by: IB Advertising
DIY - Air Cleaner
• Step by Step Instructions
• Parts Needs
• Visual Guide
Read full discussion below
• Step by Step Instructions
• Parts Needs
• Visual Guide
Read full discussion below
Small, cheap & easy do it yourself air cleaner (lots of pics)
#541
This may have already been discussed but is there a way to drill the support bracket and the air filter backing plate so a nipple can be inserted to vent crank case right back into the 4" filter using hose and a small T fitting? so that the hoses can be mostly hidden. Is there room on the edge of the filter somewhere?
like this but drilled and inserted where it can fit in between the support bracket and the engine. ( if it can)
Pardon my artistic ability..
I do realize the the pressed nipples in the crank case vent fittings would have to be pulled so that the fittings could be tapped for smaller fittings like you did with the filter that stuck out to far for your likings. But would this be doable?
like this but drilled and inserted where it can fit in between the support bracket and the engine. ( if it can)
Pardon my artistic ability..
I do realize the the pressed nipples in the crank case vent fittings would have to be pulled so that the fittings could be tapped for smaller fittings like you did with the filter that stuck out to far for your likings. But would this be doable?
#545
K9tamer I think I have seen what you are talking about on bigger bikes. Small tubes that go behind the filter and directly into the throttle body. No drilling anything, I imagine small diameter copper tubing could be fit under the filter and the bracket filed to accomodate. But like dkcustom says, hot oil/air doesn't belong in an intake performance wise. It would clean up the look tho.
#547
K9tamer I think I have seen what you are talking about on bigger bikes. Small tubes that go behind the filter and directly into the throttle body. No drilling anything, I imagine small diameter copper tubing could be fit under the filter and the bracket filed to accomodate. But like dkcustom says, hot oil/air doesn't belong in an intake performance wise. It would clean up the look tho.