2013 Iron 883 Chopper/Bobber
#11
I did have one other issue yesterday, when I changed the front brake line I had air in the system and could not get it to bleed. If anyone is having the same issue, I used a brake bleed kit from Harbor Freight. I flushed and kept trying to bleed it from the bleed bolt and the brake line bolt, but would not pressurize. The kits have a hand pump that puts pressure on the system and sucked the air out in less than two minutes. Just a tip that might help and definitely saves time!
#13
So last few things to finally wrap up my bike for the summer. On the list was to adjust throttle a bit, flush/change rear brake fluid, tidy up wires and install a USB port under the gas tank. All those items are pretty well covered but I will include some pics of the USB install and some final pics of the bike all done and detailed.
Here is a pic of the bike with the tank off battery and fuse out.
Checking to make sure the length is good and that the USB charger works.
A pic of how I ran the wire and how it will look underneath the gas tank.
So kinda hard to see but a pic of the USB port under the gas tank and hidden but easily accessible when needed.
Here is a pic of the bike with the tank off battery and fuse out.
Checking to make sure the length is good and that the USB charger works.
A pic of how I ran the wire and how it will look underneath the gas tank.
So kinda hard to see but a pic of the USB port under the gas tank and hidden but easily accessible when needed.
#14
#19
Thank you, I will post some pics today, I have been riding it for work so...
Thread
Thread Starter
Forum
Replies
Last Post
parabellum_9x19
Sportster Models
117
08-25-2021 07:29 AM
xharleyx
Sportster Models
10
03-09-2009 10:47 PM