Good quality turn signals?
#11
04-22-2019, 07:41 AM
I settled with the 2509 model from Kuryakin, they're similar to what i currently have, which i like and didn't break the bank.
Now just wanted to write a little bit on my experience with my DK bullet rear turn signals. The company has good customer service i give them that but my experience with their product is horrendous. Three hours after initial install, one of the filaments was gone leaving me with no brake light on one side. A couple days following that, the opposite light went out completely, turns out the bulb touches the lens cap and almost burn a hole through it. The reason for this is because the bulb sits loosely inside the light housing, you cant tighten it because you'll strip the thread. In short, stay away, its a very cheap product. You'd think these were a pair of amazon knockoffs running for less than 20 pair but they weren't.
Now just wanted to write a little bit on my experience with my DK bullet rear turn signals. The company has good customer service i give them that but my experience with their product is horrendous. Three hours after initial install, one of the filaments was gone leaving me with no brake light on one side. A couple days following that, the opposite light went out completely, turns out the bulb touches the lens cap and almost burn a hole through it. The reason for this is because the bulb sits loosely inside the light housing, you cant tighten it because you'll strip the thread. In short, stay away, its a very cheap product. You'd think these were a pair of amazon knockoffs running for less than 20 pair but they weren't.
The following users liked this post:
762mm (04-22-2019)
Thread
Thread Starter
Forum
Replies
Last Post