Clutch lever wont return without being pushed out.
#11
Ok, if it was the same then you could have other issues. Perhaps the spring plate in the middle of the clutch is bad
#12
John
#13
#14
Are you sure you have the correct cable? This new cable has never worked correctly? Can you post up some pictures of where the cable connects down at the clutch, so we can see if it's put together correctly? It's hard stumbling around in the dark.
You say the previous clutch worked the same? Have you checked for a broken clutch diaphragm? Maybe the clutch adjuster bearing on the adjustment rod has gone out? Maybe that's why the bike got put out in the rain?
John
You say the previous clutch worked the same? Have you checked for a broken clutch diaphragm? Maybe the clutch adjuster bearing on the adjustment rod has gone out? Maybe that's why the bike got put out in the rain?
John
Last edited by John Harper; 06-14-2018 at 05:56 PM.
#15
Thread
Thread Starter
Forum
Replies
Last Post
Brooks2131
Primary/Transmission/Driveline/Clutch
4
09-19-2018 07:36 AM