i recently purchased the harley davidson led/aux mirrors and installed the mirrors but mirrors didnt turn on am i missing something in the wiring? im sure i wired everything correctly according to the instructions provided.

 

sorry this is going on a 2014 iron 883 if that helps

 

The fuse of that kit in place and OK ?

 

ya fuses are ok and in place

 

If you have and know how to operate a multimeter (simple enough), change it to DC and check terminals on the plugs that connect to mirror wiring. That's the first thing I would do.

 

i have 20 ohms of resistance is that normal?

 

Not sure about that. Also check if you accidentally reversed the poles when connecting to battery wires. I think these are LED mirrors so reversing the pole would cause them to not work.

 

+1 on LED polarity.

 

i checked those but if those were reversed the turn signals would not work right
because the y harness powers everything

 

Grounded? Obviously you don't have a complete circuit. If it's not the ground or polarity, there is an open. Get an ohm meter and ensure all wires are good. Then ensure you have power at the potential side of your connections. Some how you need to also ensure the LED's work in the first place. Good luck.