I am trying to buy some front axle caps but can't figure out what size I need 3/4" i.d. bearing or 1" i.d. bearing anyone know my bike is an 07 I know they have changed sizes on some bikes.
On a side note to the the manual, it says only if bearing races are removed do they need to be replaced. So I am thinking I don't need the tool since I should just replace the bearings themselves.
Yup leave the races... they're still new just change the bearings.
lol...G, thats condensation from starting the heater up in the garage, doing pretty good how bout you, you staying out of the heat.....addicted, the front is 1inch the rear is 3/4.........
actually the 07's up are 25mm, just slightly larger than the 1 inch
Just for the record 25mm is smaller than 1 inch.
Exact conversion is 1 inch = 25.4 mm
Therefore 25mm/25.4 = .9842 inch
I am curious if anyone knows if what HD is calling 25mm is infact 25.4mm or really 1 inch ??