No never broke one, but sometimes we tear it up pretty good and i dump the clutch and grab a fistfull of throttle and lay a patch...lol.....i always think about the belt when i do it..........

 

ah, gotta question. I am doing my PC3 this weekend. I need to eliminate my 02 sensors. Should I just get a set of bung plugs and pull out the 02 sensors up to the connectors and set them aside?? If Im eliminating them, theres no real reason to have them in the pipes still. If I order them now, I should be able to get them by Sat . . . . hopefully

THESE

http://www.denniskirk.com/jsp/produc...fCatId=&mmyId=

 

thats wut i did, its a cleaner look..........i took em off the easy way, i cut the wires and unscrewed em and pulled the plug side out...........lol

 

Cool, thats what Im thinkin . . . .. ordered

 

carefull taking the o2 sensors out mine stripped coming out and had to braze the plugs in....no biggie but can never put o2s back in

 

hey twist, DB, no need to cut the wires. the rear sensor is right under the oil tank, its a little tricky to see but if you reach under there you can just unplug it. and the front one is 2 seconds also. lift up the tab that is right on the voltage regulator and the plug is right under there. No need to unscrew anything, the tab just clicks into place.

If im not mistaken, the PC III brings some plugs, so you dont leave the ends exposed.

And yes I would defitnetly install some bung plugs instead of leaving those ugly 02 sensors.

 

Yea man, Ive seen those plugs. I figure Ill do the PC 3 and un plug em, then do the clutch cable which I need to take the pipes off for anyways and plug em.

 

Or you could buy a PC5 or Thunderheart either with an autotune module; replace the sensors with new wide band O2 sensors... Works much better and no need to dyno... JMO

Kinda weird hearing about plugging those... I had to add them to my scoot...

 

^ I did too. My Hookers were made for a carbd model, I cut and welded in bungs a while back to accept my sensors . . . . now pluggin em up . . . . . oh well.

 

We just put a pc5 on my buddies custom and couldn't get that thing right for ****.He didn't want to use the sensors so he ended up with settling for so so gains.That's after establishing a hot line to Jamie.Got to say he's one patient dude to put up with kilroy.Tried to talk him into the sensors but a hard-head is a hard head.HeHe