Night Train Pictures
02-24-2011, 02:12 PM
Road Warrior
I got the throttle done rode it around the block. No problems.
I'm kinda liking the red for now.
Cam, the tank lift I made myself.
jcall, the tube covers that go between the trees are from Accutronix. I don't have any troubles with bumps,
just need to watch how far to lean when turning.
Story, I got a question about your tank lift set up, did you go under the gusset or drill through that plastic piece
and go on top of the gusset for that gas line that connects on the front of the tank.
I'm kinda liking the red for now.
Cam, the tank lift I made myself.
jcall, the tube covers that go between the trees are from Accutronix. I don't have any troubles with bumps,
just need to watch how far to lean when turning.
Story, I got a question about your tank lift set up, did you go under the gusset or drill through that plastic piece
and go on top of the gusset for that gas line that connects on the front of the tank.
why is that?
cant find those tube covers on the site either....
Last edited by jcallesano; 02-24-2011 at 02:18 PM.
02-24-2011, 03:10 PM
Road Master
Join Date: Oct 2008
Location: Upenya
Posts: 839
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Story.
Tart that red does kinda pop in the picture, it's really not that bright.
Jcall, just being lowered it'll scrap easier.
They're call beauty tubes.
http://www.accutronix.com/products/t...rees/TT4.shtml
Tart that red does kinda pop in the picture, it's really not that bright.
Jcall, just being lowered it'll scrap easier.
They're call beauty tubes.
http://www.accutronix.com/products/t...rees/TT4.shtml
02-24-2011, 03:31 PM
02-24-2011, 04:47 PM
02-24-2011, 05:22 PM
Road Master
Join Date: Oct 2008
Location: Upenya
Posts: 839
Likes: 0
Received 0 Likes
on
0 Posts
yep, got a couple of short bolts with some acorn nuts.
Went to Napa for the fuel line and hose clamps. Home Depot for the nuts,bolts and piece of metal.
This is a 3" one I made a while back, It just didn't look right. Too high.
Don't think you'll need this much of a bend to them but you should bend them a little.
there is a kit out there for $25 or so.
2-23-11.jpg?t=1298588937
02-24-2011, 05:34 PM
02-24-2011, 06:45 PM
Road Master
Join Date: May 2010
Location: Charleston, SC
Posts: 910
Likes: 0
Received 0 Likes
on
0 Posts
Lundee- That shovel bob is sweet man Nice Work. I have been doing a lot of soul searching trying to figure out if I'd rather try and start a bobber from frame up or starting a Street Glide fund. I can usually stash a few buck here and there but I'll need a hefty lump to put down on a glide. Riding an having a radio just seems like the POO to me.