Fits 82 and up Harley softails, dynas, sportsers and touring models (without batwing fairing).

• 16 " Rise
• High quality, steel tubing with black powder coat finish
• Notched ends for throttle-by-wire or standard throttle bikes
• Bars are dimpled and drilled for wiring and handlebar controls
• These 1 1/2" diameter bars measure 35" wide and have an approx 6" overall pullback
• Diameter is 1" at clamping portion for Handle Bar control
• Made from 1 1/2” steel

Dimensions of Handle Bars

• 16" rise
• Pull Back: 6-7"
• Width at top: 35"
• Width at bottom outside: 13 1/2"
• Width at the bottom inside 10 1/2
• Width at inside clamping: 5 1/2"
• Bars fit forks with riser spacing of 3 1/2" knurling on center standard on Harley

Bars are in good shape. Couple flaws in coating at controls - never saw until I pulled bars from bike. Bars looked great on my 2001 Fatboy. Price - $135

Also have a a set of brand new, never mounted grips for throttle cable. Cost $75+ new - asking $60.

Will sell grips & bars together for $185.

 

pm sent

 

PM answered

 

pm sent

 

Several have asked for pics of bars and blemished areas. Here are several pics - last two show some bubbling PC at the brake control and a spot on one of the uprights where cable rubbed thru PC. The wear spot was taped off and quickly hit with spray paint. Never wet sanded or used rubbing compound to get rid of tape lines, but this could be done easily. I never saw the spot at the control until I removed the bars, but same could be done there. I would not spend money PC’ing the bars, as they are in very good shape - just minor touch up at the two spots.

 

Here are the last two pics with blems - could not post that many pics on one post.

 

Bars are sold. Grips still available.