I don't like how the HD rear turn signal relocation kit the one with the frender brace extenders ...extends them past the fender..

Any Ideas on what I could do about that? I put them on... and really don't like them at all, but I have detachable bags and sissybar, so they called for that specific kit...

Like some mini turnsignal bullets? that go on the fender brace(the chrome one) but dont need the exteder that will clear the detachables?


[IMG]local://upfiles/26427/B793E8B5770B43EEA97E557E9601268E.jpg[/IMG]

 

I went with mini LED flush, strut mount, rear blinkers, to clear my saddle bags.
Tom

[IMG]local://upfiles/18321/4F84DA89C3CA458FA74AEEBD389480F2.jpg[/IMG]

 

I like that mini LED setup Tom, looks great.Who's is that? Kuryakyn?

 

Use your hands. Take them off. You dont need them IMOP. Buy one with them in the taillight. If you want them go small.

 

Yes,they are from Kuryakyn.
I also added a tailbones converter from Biketronics. It lets the rear signals alsofunction as auxilary brake and running lights.
Tom

 

Hey tom, do you have a part number for the mini leds you used? thanks in advance

 

330-641 for the red lens and 330-642 for the amber lens. They are on page 392 of the J&P Cycle catalog. They come with the clear lens. You have to remove a set screw to change to the other lens color, which comes separator in the box. Make sure to change the lens before installing the lights. You can't get to the set screw once the lights are installed.
Tom

 

Sweet found em in the J&P 07 cat exactly where you said they were.. 79.99

thanks

 

Heh I gotta ask a question, where did you "stuff" all the little wires and connectors for the tailbone and led strut turn signals?
Is that the stock rear light?.. the stock don't have much room!!

 

heres a link to the LED turnsigs:

http://www.jpcycles.com/productgroup...f-6c21c4d1ad47

the pics on jp cycles looks like the LEDs are part of the Lens. but I guess not. They must be White LED bulbs and you change the LENS cap to what color you want to show or leave as is for WHITE. why would anyone use white?

so you will need to install a load resistor with these then? since they are LED bulbs?