Where in northern maine are you?? I'm in southern maine and I'm fed up with this damn weather!!!!

 

I FINALLY made plans on getting my handle bars changed. I'm going with 6" straight risers and a 1 1/4" drag bar, for the inner wiring. The "T" bar options for the Blackline are ugly or too tall.

Easier in the week, I put on a set of Kurikyan under seat passenger foot peg mounts but I switched the right and left, since I wanted to raise the pegs for my 4'11" wife. And I didn't want her feet under my butt.

 

Haven't seen it... hope all is well and good out there.

 

Well so far today got my DK Customs wolo horn installed, DK Customs 2" deluxe tank lift on, got my Furl Moto EFI tuner put on and half done with my DK Customs Outlaw 587 A/C with external breather, need some SS washers for spacers. Will finish that tomorrow along with my DK Customs Torque inserts. Then fuel her back up and take a little spin. Little cool yet here so won't go too far but have to take a test run.

 

I did my shake down break in 50 mile run!

It is nice and warm today!

 

First ride in on the new bike. 45 deg finally. 150 miles trying to get to the 500 mile break in.




Back into low 30's tomorrow and Monday but tues looks promising!

 

Welded knuckles to the frame.

 

About a week ago I had the Softail on the Dyno, testing out a bunch of parts. Before taking it to the Dyno I pulled my color matched Outlaw Cyclone air cleaner off, so as not to mess it up while changing out parts with the bike on the Dyno.

I had replaced it with an old scratched up A/C, and yesterday when I was at the shop on it some Customers stopped by and were looking at it and wondered why I had that A/C cover on it. lol

I just put the color matched A/C back on, and tomorrow Mary and I are going to go for a long ride on back country roads. Supposed to be 60*.

 

...... Softy ....... I gots a Ride in too ........

 

Looking at the close ups of your engine I think I will consider chrome valve covers and cam cover. Sure is shiny!