new pipe and retune. Just want some bigger tubes for the cubes.
Going with a 2 inch primary rb racing prostock. No baffle with the 12 degree collector. Looks like the pic above. The work for built motors. My buddy just put one on his s&s 111 in place of his thunderheader and picked up 9 hp and 2 tq.
****in-A right! Welcome to the party, pal! You're gonna love that pipe!
Here are the parts needed: The part number is 1311d for the self sealing screws.
Console 71340-11 $150 USD
Trim insert 72775-11 $15 USD
Inst. Moulding 71576-08a (need 2 of these) $5 USD x 2 = $10 USD
Top Plate 60900001 $45 USD Total = $ 220 USD
This list is getting quite dated so prices have no doubt changed for the worse. Nonetheless, these are the parts you'll need for the dash installation. I had mine chromed which cost another 150 bux at the time.
Enjoy !
Just wanted to ask about the 0311d Self Sealing Screws. Is this for the top plate? Will we need a quantity of 10? Thanks.........
Just got a clutch recall notice in the mail, what exactly is being replaced on it and how long does it usually take? Not that mine is going anywhere for several months now:/
Just got a clutch recall notice in the mail, what exactly is being replaced on it and how long does it usually take? Not that mine is going anywhere for several months now:/
Hi Vince,
Got mine in the mail yesterday, mine too will not be going far in the next few months, I'll probably wait until Spring. My recall notice explained what was involved and the duration.
Finally decided to 'balance up' the bike after the recent rear fender swap out and Shotgun Shock fitting and removed the bellypan fairing to get it painted and hydrographically 3D carbon dipped black with a high gloss finish. Won't be ready until after Christmas.
Festive greetings from the UK South Coast to everyone that stumbles across this post! Happy Christmas Everyone!
Finally decided to 'balance up' the bike after the recent rear fender swap out and Shotgun Shock fitting and removed the bellypan fairing to get it painted and hydrographically 3D carbon dipped black with a high gloss finish. Won't be ready until after Christmas.
Festive greetings from the UK South Coast to everyone that stumbles across this post! Happy Christmas Everyone!
Thanks a lot! That front piece is going to look great with the rear fender, you’ll definitely have a one if a kind there, have a merry Christmas and let’s hope the winter goes fast and painless!!
Ok, let's make this thread the place to post about anything having to do with the Softail Breakout. Maybe you just bolted on a sweet new part and you want to show it off? Can't find the part your looking for? Need a little advice on what looks best on a Breakout?
This can be the place we discuss it. I'll post a pic just to get the thread going.
24V, what year is your bike and what is the colour name? Was considering replacing my Hard Candy Custom paint set with Black but the more I see pictures
of your bike the more I like the colour. Might even be a close match to my 2017 Ford Ruby Red Metallic truck.
02-13-2015, 01:41 PM
