Lets see those Softail Bobbers
#111
Yes you can do this with the "tractor" style seat, but the problem is
you need to use the correct frame cover kit. I'm thinking the one
shown for the scissors type spring seat will work with the coil springs,
but I'm not positive. If you use the kit for the 'bones, the ECM cover
wont fit correctly with the Slim's narrow rear fender.... So, do some
research, look on page 192 of the new '14 Parts & Accessory manual
for starters....
hth,
T.
you need to use the correct frame cover kit. I'm thinking the one
shown for the scissors type spring seat will work with the coil springs,
but I'm not positive. If you use the kit for the 'bones, the ECM cover
wont fit correctly with the Slim's narrow rear fender.... So, do some
research, look on page 192 of the new '14 Parts & Accessory manual
for starters....
hth,
T.
together. You need the coil-spring frame cover and the scissors spring
seat ECM cover. These are available separately if you have the part
numbers. Someone with the installation instructions should have these.
I can look part of them up for you since I used the scissors style kit for
my pogo-style '25 police seat (tractor) installation. I'll try to reply
back on this thread.
T.
#114
Nameless took very good of me and hooked me up with a rear fender.
I'm sure if you hit him up he would give you any last minute suggestions.
#116
#118
Ha Ha , Good Luck , I Cut mine about 3 times before I got it the way I wanted it . AND make sure you Hang it on the bike after each cut so you know where you are , It's Fun once you get goin.... I also used blue masking tape to mark my Cuts ..
Last edited by dennyo; 01-11-2014 at 06:46 PM.
#119
My mistake, I was looking at it backwards...I think ur length looks good.
#120