Originally Posted by murfe

Created a thread about it here: https://www.hdforums.com/forum/softa...-switches.html

I kept the switches in their stock config, created backing brackets from two strips of sheet metal, bent those to conform to the backside of the switches, drilled holes in top and bottom for bolts to secure everything, and the finishing touch was the switches to brackets with some of that superstrength velcro (the 10lb kind).
Works great, have put on about 1000 miles since and absolutely no worries.

I'll go back and revise with more detail on the other thread when I get a chance.

Originally Posted by murfe

Yeah, I think so. I like the look of it. Took this while changing Primary fluid, so that cover is already back on.

EDIT: might take a dremel with sanding disk to it to get a more uniform swirl pattern.

Originally Posted by murfe

Yeah, I think so. I like the look of it. Took this while changing Primary fluid, so that cover is already back on.

EDIT: might take a dremel with sanding disk to it to get a more uniform swirl pattern.

Originally Posted by splattttttt

it's your bike and it is a beautiful sled non the less. Thanks for your reply

Originally Posted by splattttttt

I like your second attempt much more. Looks almosr jeweled.

Originally Posted by murfe

Went a little harder with the covers. lots of time doing little swirls with a wire brush attachment.





Here's the Primary before with just sandpaper rub...