Need Help with taking the front wheel off
#11
fireb
check out my post on progressive here
https://www.hdforums.com/forum/softa...pictorial.html
ill get you size in a minute................
***note*** also easier to at least break it loose when wheel is on ground, then jack up, then remove
check out my post on progressive here
https://www.hdforums.com/forum/softa...pictorial.html
ill get you size in a minute................
***note*** also easier to at least break it loose when wheel is on ground, then jack up, then remove
Let me know about that gigantic Hex for the both sides!
If you know where to get it too, I'd appreciate it........
But at the same time, how the hell would you know the torque for that thing?!
I'm sure that it doesn't come with a socket for the torque wrench?!
#12
#15
I went to 2 Sears around my town and they both didn't have the 3/4 Hex!
They had the 14mm but in a set with some standards... How does that happen?
And it was $40 with 4 hex so I just figured I'll just get it online from sears and purchase the single unit.
It's not a common Hex I assume.....LOL
They had the 14mm but in a set with some standards... How does that happen?
And it was $40 with 4 hex so I just figured I'll just get it online from sears and purchase the single unit.
It's not a common Hex I assume.....LOL
#17
I just figured I'd go to harbor freight since that is close by.
My man Mike who sold me the fender has such good idea with putting this fender on.
Thread
Thread Starter
Forum
Replies
Last Post