I am dropping my 11 Cross Bones off today to have the Woods 777 cams with Woods lifters and the premium SE tapered push rods plus a Power Commander V today. The mechanic said its gonna take around 5 hours. I can not wait !!!!

 

Will you be getting it dyno'ed?

 

Not right away but it will be done before the spring. How did you make out with your power commander coming to you pre mapped? My mechanic said it will be at least 95% dead on ***** but getting it dyno'ed with get the all that it has to offer out of it.

 

That's awesome, I just received my tw-777 cams from fuelmoto yesterday, just looking for a needle bearing installer/remover so I can install them on my 07 standard

 

Be sure your mechanic follows the instuctions of the lifter install exactly or you'll have clatter and will need to re-adjust the push rods.

 

He was asking if the needed to be primed or something. I don't know what he said but he did ask something about them and looked at the directions and said he has to do something to them. I know that pretty vague but does that sound kinda like what your talking about?

 

They do not need to be primed, but they have to have the correct pre-load. It's different than stock.

 

So what did they have to do to get the Power Commander to work on a 2011 Crossbones. All of the notes on the Dynojet website says they do not work on the 2011 Crossbones.

 

Your avatar is mesmerizing.. I can watch it forever..
No idea but looking on the FuelMoto website it says right there that it will work and I spoke to them on the phone.

http://www.fuelmotousa.com/pcvharley.htm

 

well she's all done and she runs awesome. She even pulls in 6th gear. Im very happy with this set up. I'll do another video later when she all warmed up. Sounds awesome as well.


http://www.youtube.com/watch?v=-6K-x...Nkw8NrrKQChA8U