tank lift pic
#33
Nice. I ordered a 2" lift and then looked at what it would take to do it myself. I have quite a few pieces of stock to work with, now to cut them down, drill the holes and clean them up and powder coat them. Me thinks this will be fun.
As far as fuel in the tank, that shouldn't change, in fact it may even go up a bit at a little more angle. I just added the Kury fuel gauge too and it can be programmed to show empty wherever you want it to, so I may just do this and reprogram it a bit lower than it is to make up for the angle.
was there much more than the brackets to install? I assume it is just to add a bit of length to the fuel crossover and install brackets. Yes? no?
As far as fuel in the tank, that shouldn't change, in fact it may even go up a bit at a little more angle. I just added the Kury fuel gauge too and it can be programmed to show empty wherever you want it to, so I may just do this and reprogram it a bit lower than it is to make up for the angle.
was there much more than the brackets to install? I assume it is just to add a bit of length to the fuel crossover and install brackets. Yes? no?
#36
#38