Its just cast aluminum, easy drilling. Just work up to the size you need. I did mine on a drill press, so I protected everything with several layers of electrical tape. No damage.
Made a cheap small jig from poplar. Combined with a couple of clamps, it guarantees that the drill bit won't wander and that your hole will be exactly where you want it (in line with the original switch) and with no chipping. It is shown in the earlier pictures that I posted.
Hey i was looking at this mod for my rocker then I seen theres no real good place to install the extra button on the console.Got me thinking what would happen if i spliced the opener to the switch thats allready there.So if you go to cycle threw the trip a time itll open the door? anyone see any problems with this??
Hey i was looking at this mod for my rocker then I seen theres no real good place to install the extra button on the console.Got me thinking what would happen if i spliced the opener to the switch thats allready there.So if you go to cycle threw the trip a time itll open the door? anyone see any problems with this??
check the voltage the trip reset puts out, it might be a full 12v. your average door opener is 3v. can you say fire? just to be on the safe side i would check it first.