Mario, you have mail

 

Mine is the Heartland 250 Bobber kit. The rear wheel was previously purchased for a custom frame with no off-set on the hub.

 

Tx, Thanks

 

I had to modify it. Took off the L brackets on either side and put a seat bolt on the back middle. Took it off my old pillion. Looks ok but want to have a custom seat made

 

Also there's a couple of speciality tools in rebuilding the removing the clutch and rebuilding the tranny. I had a friend with a shop and borrowed the tools. Just to let you know.

 

I have got to get a seat made. I Fitted the stretched gas tanks last night & the tanks measure 22" long, 7.5" wide, the mustang seat I had will not fit. Of all the things I plan to do I think that’s the one that will give me the most problems. I am lucky with the transmission my buddy’s got all the tools

 

So, Sig, did you get your kit yet?

GW

 

I received the kit all looks good all I need is a belt, I got a 70t pulley with my wheels so had to get a longer belt. The kit came with a 3/4 axle wheels have 1 hub so more things to do. I have stripped most things down, been working on my new dash I got a Big Dog dash Speedo & tech moved the coil had a few problems but I will be working on the wide tire kit any day

 

SIG
I've been looking at this kit myself...Could you also send me a copy of the installation directions? brownbj1@apci.com Thanks!

 

Sig,

Can you email me a copy of that article to rainmanv2@***.net, thanks.