Calling all FatBoy Lo Owners
#712
yeah i tried that didnt get the finger prints or water marks off....im a perfectionist...have been able to clean it well with stainless steel kitchen wipes that u use on your microwave n fridge......but after having chrome that blings after u clean it i just cant go back
#713
yeah i tried that didnt get the finger prints or water marks off....im a perfectionist...have been able to clean it well with stainless steel kitchen wipes that u use on your microwave n fridge......but after having chrome that blings after u clean it i just cant go back
I use nevr dull, cleans that satin finish nicely. Apply it and then buff out with a soft cloth.
Dave
#714
I agree Dave. Nevr-Dull works awesome on all metals!! Plus it is so easy to use.
Hey Earl, the license plate bracket I'm using is a Cycle Visions Eliminator. Here's the link.....
http://www.cyclevisions.com/road-rod...black-cv4802b/
It's a little pricey, but I was fortunate to get mine at the local dealership on the 75% off rack. Was chrome, but a little HD satin spray paint was all it needed!
Hey Earl, the license plate bracket I'm using is a Cycle Visions Eliminator. Here's the link.....
http://www.cyclevisions.com/road-rod...black-cv4802b/
It's a little pricey, but I was fortunate to get mine at the local dealership on the 75% off rack. Was chrome, but a little HD satin spray paint was all it needed!
#715
I just made this my self out of 3mm plate 275 mm high 100mm wide with a tab 75mm centre up from the bottom on the right hand side , the tab was square until i bent it around sideways then i just shaped it with the grinder and drillled a hole in the centre for the axle bolt.
the light is a $7 dollar trailer light from supercheap you could get one from home depot and then just cut 3 small strips of rebar and welded them around the light run the wiring and soldered and heat wraped all up it cost about $20
If you want a full drawing let me know i will do one up but it will really depend on the light you buy just sit your light above your plate and trace around it and then fab it up ,its better than paying $180 dollarsfor a custom one
#716
As long as you use a trouque wrench to do it up again there is no issues set to spec in book you should bechecking the nut reaulay anyway even though it has a sir clip on it
#717
#718
Are those HD street slammer bars?
I'm really torn between 4" pull back risers, 16" apes, or the street slammers.
#719