rocker rear axle
#11
I have the 24 piece VIM Tools Hex Master Set:
13-pc Metric hex 2mm thru 19mm.
13-pc SAE fractional hex 3/32" thru 3/4".
S2 steel drive bits in knurled chrome holders.
1/4", 3/8" and 1/2" square drives.
Plastic storage case.
Lifetime warranty.
S2 steel, the strongest hardest drivers available
I use it all the time and is well worth the money.
In regard to the axel mount plat I agree with rail, Top-Down Products makes the best one out there and the customer service is second to none.
13-pc Metric hex 2mm thru 19mm.
13-pc SAE fractional hex 3/32" thru 3/4".
S2 steel drive bits in knurled chrome holders.
1/4", 3/8" and 1/2" square drives.
Plastic storage case.
Lifetime warranty.
S2 steel, the strongest hardest drivers available
I use it all the time and is well worth the money.
In regard to the axel mount plat I agree with rail, Top-Down Products makes the best one out there and the customer service is second to none.
#12
that's my problem i was wondering about the recess and how the fit would be i bought one not thinking now i gota find out how to make it work
#14
Top Down Products Accessories
Dennis
Top Down Products
Dennis.Sauro@topdownproducts.com
www.topdownproducts.com
#15
We do offer just the Axle Nut Kit as an accessory. It comes with a new axle nut, adapter hub and 1/2" button head/washer hardware. This would let you mount your side mount off the axle using the 1/2" bolt, assuming you have at least a 1/2+ hole in the side mount. The link is below.
Top Down Products Accessories
Dennis
Top Down Products
Dennis.Sauro@topdownproducts.com
www.topdownproducts.com
Top Down Products Accessories
Dennis
Top Down Products
Dennis.Sauro@topdownproducts.com
www.topdownproducts.com
#16
#17
#20
If its a side mount plate? Find the wire before it goes into the fender then re-route (splice it or cut at the current posiition and pull it out) it by the swing arm to the plate many ways to secure it at various points where it wont be visible...