You might want to ask chuck (outlaw) for which two wires you switch at that Coil so you can have the wires not crossed up.

 

How about a 69 Road runner horn mopar of course... they sound like this.. BEEP.. BEEP.. just like a roadrunner!

 

Are you doing anything for some light on the tag? I guess that may be a state by state thing on tag lights.

 

Looking good!!

 

looking at getting one of these frames
they are on ebay for about $18 shipped


or some bolts with led in them tip.
again ebay for less than $15 shipped

 

I am embarrassed to say this...
but I have put the bike together and found two remaining screws that I can't find a home for...

anyone have any ideas ?
anyone have their tank off and can make sure it does not go under there somewhere ?

I only took apart/removed the front end, the tank, seat, coil, horn, and rear shocks...

Please help a brother out.
pic below

 

Looks great!,
Mine was looking pretty close to this condition for about the past 2 weeks by doing the bars (internal wiring), shocks and pipes.
Definately like where you are heading with this build.

Ray

 

I didn't see any screws like those under the tank.
check your original coil bracket or what was left over from the horn.
Didn't you also state that you took off the frame post just in front of the oil bag?

Hope this helps

 

thanx for checking man...
yup, done that already and all is accounted for with those...

just these two remain.
I am baffled
chris

 

them bolts look like the ones in the front sigs clamp, yet you've got'em installed...so...??...did u tinker with the oil bag?

what wire gauge did u use for the coil?

here's a link in case u want to switch the plug wires...thanks to tx_outlaw

https://www.hdforums.com/forum/softa...tures-447.html

u've done a great job....thanks for d ideas and inspiration